Patterson has been awarded with the NADCA Safety Award for 2014. Patterson was awarded the NADCA Safety Award for 2014!  NADCA’s Safety award only recognizes NADCA Corporate Members that have maintained a safety record equal to or less than 4.0, the national average for all manufacturing. Congratulations, and good job, Patterson associates!

In October 2014, Patterson Mold & Tool officially broke ground on the new 10,000 sqft. building expansion.  The first step was to pour a new employee parking lot to replace the one that occupied the space where the new expansion would be located.  In January 2015, the old parking lot was torn up and dug out for the foundation of the new addition.  Following some weather delays, the foundation pillars were poured, and the vertical structure of the addition started going into place late in February.

Patterson Mold & Tool has purchased and installed a new Sodick AQ750LH high-capacity wire EDM machine.

Patterson Mold & Tool is growing again! Ground has been broken on our newest expansion, a 10,500 sq. ft. addition on the south side of our building. The new addition will include a 25-ton crane to handle larger dies, and a new break room for our employees.

Patterson Mold & Tool purchased a ROMER Scanning Arm from Hexagon Metrology, to be used for quality assurance, inspection, and reverse engineering.